Sorry about that. I forgot to set the timezone when setting up the poll, and it looks like I cannot change it now. So I created a new poll. Please use the link below, it should now allow you to adjust the time zone local via a drop down menu at the top of the poll. http://www.doodle.com/yifhpi5emyyzrspa Thanks for letting me know. -- Josh On Tue, Jan 31, 2012 at 3:44 PM, Dries Kimpe <[email protected]> wrote:

What's the time zone for the times listed in the doodle poll? Or does doodle automatically adjust?

Dries

* Josh Hursey <[email protected]> [2012-01-31 12:52:58]:

...

(Cross posted to both the I/O and FT MPI-3 listservs)

...

During the FT plenary session at the Jan. MPI Forum meeting there were some concerns about fault tolerance semantics in the I/O chapter. We did not have much time to fully discuss the additional semantics during the meeting. To make sure that we push towards a complete set of semantics useful for the I/O community in the next draft I would like to have a teleconf to discuss the I/O chapter of the FT proposal. Preferability in the next week and a half (so we have time to fine tune things before the next forum meeting).

...

Below is a link to a doodle poll to find a good time for a teleconf. If you are interested in participating in this discussion, please fill this poll out by 2 PM Eastern on Thurs. Feb. 2 so we can set the date/time. http://www.doodle.com/s3hz9daeh8pn483m

...

Thanks, Josh

_______________________________________________ mpi3-ft mailing list [email protected] http://lists.mpi-forum.org/mailman/listinfo.cgi/mpi3-ft

-- Joshua Hursey Postdoctoral Research Associate Oak Ridge National Laboratory http://users.nccs.gov/~jjhursey